GRT Avionics

Hi, I have a Horizon 10.1 and a SPORT EX with the OAT probe connected to my EIS 4000.

Is there a way to have calculated density altitude shown on the EFIS?

Thanks for your help,
Louis

Hi Jeff. I went into my General Setup-SerialPort Input and Output config setting and found that they were at standard servo. I changed it to GRT Servo Enhanced. I saw also that there was a GRT Servo Standard option. What is the difference between all these AP servo control profiles ?

"Trim alerts are always about forces and torque, not about gain. Gain is about how aggressive the autopilot is. If the autopilot is unable to level off that could mean it doesn't have enough torque or it could mean the trim is too strong for it."

Totally agree Jeff, but if it was a question of ...

Hi. After Pitch and Roll Servo installation, I have a hard time adjusting the parameters to have good flight characteristics without oscillations or overshoot. In Roll, it goes pretty good with small oscillations however and those roll oscillations are similar to a dutch roll movement. Right now ...

Hi, I have a Horizon 10.1 and a Sport EX MFDs connected to the same pitot/static system of my aircraft. In flight at cruise speed, there is a difference of approximately 1.5 knot between the two MFDs. Is there a way to calibrate indicated airspeed?

Also, i noticed that my ground speed is always ...