Search found 8 matches

by Sal
Thu Aug 18, 2022 6:51 am
Forum: EIS Sensors
Topic: EGT oscilation
Replies: 3
Views: 2251

Re: EGT oscilation

Hello Jeff I swapped EGT Leads from Cylinder 4 to Cylinder 2 and Cylinder 2 Leads to Cylinder 4 The oscilation stayed at Cylinder 4 although it was reading Cylinder 2. There have been no changes made to the position of leads and they do not run close or paralell to ignition leads. So I was thinking ...
by Sal
Fri Aug 12, 2022 9:21 am
Forum: EIS Sensors
Topic: EGT oscilation
Replies: 3
Views: 2251

EGT oscilation

I have egt sensors cylinder 3 and 4 oscilating about 5 to 8 degress centergrade in a short cycle. Would this be failing probes. the engine only has 140 hours. any suggestions appreciated.
https://www.dropbox.com/s/z0i4963sidknp ... e.JPG?dl=0
by Sal
Fri Feb 25, 2022 8:19 am
Forum: EIS Sensors
Topic: EGT / CHT Wire Leads
Replies: 9
Views: 13564

Re: EGT / CHT Wire Leads

I have checked out my wiring spread sheet and it does say that the CHT wires are red and white and the EGT wires are red and yellow. The GRT EIS loom was long enough to reach the EGT and CHT sensor wiring they are joined with the red connectors So you think my system is wired correctly and should be...
by Sal
Thu Feb 24, 2022 7:39 am
Forum: EIS Sensors
Topic: EGT / CHT Wire Leads
Replies: 9
Views: 13564

Re: EGT / CHT Wire Leads

Jeff are you saying the thermo couple wire has to run all the way back to the D sub connector on the EIS. I was supplied with GRT EGT probes, S/S clamp style with a set of red connectors. I have used the red connectors between the thermo couple wires and the supplied GRT loom, that connection is for...
by Sal
Thu Feb 24, 2022 12:25 am
Forum: EIS Sensors
Topic: EGT / CHT Wire Leads
Replies: 9
Views: 13564

Re: EGT / CHT Wire Leads

I am experiencing high EGTs it is a camit 3300 engine. The camit supplied CHT sensors have their cold connection in the cabin while the GRT supplied EGT sensors have their cold connections in the engine compartment at a much higher temp. would this be causing some sort of calibration error. I note i...
by Sal
Tue Sep 07, 2021 5:47 am
Forum: Horizon HXr
Topic: Connector A18
Replies: 11
Views: 34097

Re: Connector A18

Thanks Jeff and Bob,
sounds like I should connect up A18 :)
by Sal
Fri Sep 03, 2021 9:55 am
Forum: Horizon HXr
Topic: Connector A18
Replies: 11
Views: 34097

Re: Connector A18

Jeff
What sort of drain on the battery would you expect.
by Sal
Tue Aug 31, 2021 12:51 am
Forum: Horizon HXr
Topic: Connector A18
Replies: 11
Views: 34097

Re: Connector A18

Found this old post. I do not have anything connected to A18. would this be why my flight log data output is dated 2002. My Clock has the right time but doesn't get the date. You can manually load the correct date but it seems to lose it after shut down. Trying to get the correct date on flight log....