GRT Avionics

Rob The gearbox temp on a EIS 2000 EGG is astually a CHT thermocouple lead modified to use the gearbox temp sender. the information is on the HXR as a CHT not the gearbox temp. The only way that we have to display the temp the right way is to have you upgrade the EIS to the model 4000. That would gi...

That is the old one. Whats the new one look like?

Kahuna is probably on the right track. Page 19 in the EIS 4000 manual talks about the D/I (decimal/integer settings). Change that Aux to an Integer(I) and it should eliminate the decimal point.

Ben

Boomer

Pin 3 Out of the IFLY620 is right. Did you setup the IFLY for the baud rate that you chose? in the setup of the IFLY you tell it which baud rate and NMEA sentence structure to use. The Sport EFIS can take any baud rate and is a standard NMEA0183 serial sentence.

Hope that helps

Ben

Smokey

The "Pattern" page is in development. we are trying to have something for the HXr systems by the end of the week and the HX and Sport systems by the end of the month.

I will keep you informed.

Ben

Mike

We would not mind being able to support the GDL 39 system. We just need a unit to test and use to create software. If you know someone that has one and would be willing to let us use it for a few weeks let me know.

Ben

Mike The audio output on the EFIS systems is something that has been on the docet for a long time, but because it is a low wpriority item it gets push to the bottom of the list all the time. we intend to make the audio output a full 16 bit mono output. But there is currently no timetable for writing...

Mike The Gains for the Autopilot that are found on the Set menu, General Setup page, Give the Autopilot an exact target to shoot for. The Servo Gains on the Set Menu, Autpilot Maintenance page, can be thought of as the tolerance the servos use to maintani the point given by the normal gains. The ful...

Run theough the princeton calibration procedure. that will give a 0v at empty and 5 volts at full. then just need to scale the eis read out For EIS setup of the capacitive plates there is no Offset(AUXOFF)(set to 0). The Scale factor for the EIS should be set to half of what you want it to read when...

Mike With the 301 ohm resister installed between the 4.8 excitation and the aux line. And the aux line connected to the pressure sender(Parallel the 4.8v excitation line with the Aux line through the resister).The values are with the 80 PSI sender AuxSF is 91 AuxOFF is 15 If it is the 150 PSI sender...