Search found 803 matches
- Mon Oct 16, 2023 11:56 pm
- Forum: Mini B/X/AP/GA
- Topic: set up a/p
- Replies: 1
- Views: 5567
Re: set up a/p
The Mini settings are a little simplified for these. They are automatically turned on if available and can't be changed in the SET MENU. The Mini-X always has lateral functions enabled (vertical is altitude hold only). The Mini-AP always enables both lateral and vertical functions.
- Fri Oct 13, 2023 3:12 am
- Forum: Horizon HX
- Topic: GRT Dual Band ADS-B Receiver
- Replies: 2
- Views: 4918
Re: GRT Dual Band ADS-B Receiver
Traffic would be displayed as part of the PFD 3D Synthetic Vision view if it's in front of you. Synthetic Vision mode requires heading, altitude information, and GPS position to work. The "ON" or "TERRAIN" mode must be selected on the "SV" button. "Traffic in view&...
- Thu Oct 05, 2023 12:23 am
- Forum: Horizon HXr
- Topic: HxR: EGT/CHT History timeline - changable?
- Replies: 5
- Views: 16824
Re: HxR: EGT/CHT History timeline - changable?
The Mini, EX, SX, HX, WS, and HS have a separate "EGT" display mode that shows both types of graphs side by side and matches the colors. On the full EGT/CHT display, the Mini and those other displays don't show the colors (example on Mini install page 73). The inset graphics on the HXr and...
- Mon Aug 28, 2023 11:41 pm
- Forum: Mini B/X/AP/GA
- Topic: autopilot
- Replies: 2
- Views: 4111
Re: autopilot
That should have engaged at least. The EFIS would hold heading automatically. If you have a Mini-X it would hold altitude. If you have a Mini-AP it will hold pitch (so you can engage during a climb). You should also get a pop-up menu of A/P modes to decide what to do next. Did you complete the setup...
- Fri Aug 25, 2023 4:52 am
- Forum: Horizon HX
- Topic: RPM Display N1/N2
- Replies: 1
- Views: 3523
Re: RPM Display N1/N2
The standard tach inputs for a piston engine EIS and "RPM" display work this way since around EIS software version 75 (2009). If your EIS has software to show two independent tach readings such as on a turboprop/turbine then it will work differently. If you are showing "N1" or &q...
- Thu Aug 24, 2023 3:01 am
- Forum: ADS-B/Weather/Traffic
- Topic: Discovery ADS-B WiFi Connection
- Replies: 4
- Views: 15537
Re: Discovery ADS-B WiFi Connection
Given that I have the Discovery ADS-B Wi-Fi Connection, Might it be possible, since my iPad is speaking with this device, To ADD the ability RECEIVE my flight plan that is in FOREFLIGHT on my GRT EFIS??????? Future capability is possible. There are no published interfaces for flight plan transfer w...
- Tue Aug 22, 2023 5:46 am
- Forum: Autopilot
- Topic: Fan ventilation for servos
- Replies: 1
- Views: 7952
Re: Fan ventilation for servos
The servos don't have power outputs so you're just picking off power from your power switch in the end. It should be fine. I don't recall any cases of someone doing that and having that be a problem. The servos don't have temperature sensors but they can sense overheating by other means. If the EFIS...
- Fri Jun 23, 2023 4:25 am
- Forum: Horizon 10.1/Sport 10.1
- Topic: Upgrading to aural warnings
- Replies: 6
- Views: 57631
Re: Upgrading to aural warnings
The 10.1 has audio output pins in one of the D-sub connectors. Usually these wires have not been installed unless the builder has installed them or someone told their installer to install them. Wires have to be installed into the Connector "B" 25-pin D-sub on the back of the 10.1 display a...
- Thu Jun 15, 2023 8:49 pm
- Forum: Autopilot
- Topic: Roll Trim required message
- Replies: 4
- Views: 13079
Re: Roll Trim required message
You can leave the body in as long as it doesn't interfere with the safety operation. It is held in by red loctite so trying to remove it is not recommended. There are 2 more holes in the cylinder shear base that you can rotate under the arm. The shear screw is a custom part. You have to order it fro...
- Fri Jun 02, 2023 10:29 pm
- Forum: Horizon HXr
- Topic: Software Updates
- Replies: 2
- Views: 8028
Re: Software Updates
Usually the problem is that your web browser has changed the name of the file by adding numbers and dashes or parentheses. Many browsers now automatically rename the file if they know you've downloaded a file with the same name before. Check the name of the HHXRUp.dat file on your drive. If it has a...