Page 1 of 1

Map Page Insets

PostPosted: Sun Mar 27, 2016 4:48 pm
by Bayou Bert
When I go to the Map Page I see the two soft buttons, each side, that say inset.
If I push either, I get nothing, no inset options. A note does pop up just over that says "hold for default" and
that produces nothing.
I saw on one of Jerry's videos he had a small HSI in one corner and EGT/CHT in the other.
What am I not doing or need to do?

Thanks
Bert

Re: Map Page Insets

PostPosted: Mon Mar 28, 2016 2:13 pm
by gdtrfb58
Check if you have the map set to "North Up" instead of "Course Up". You cannot display the Insets when set to "North Up"

Re: Map Page Insets

PostPosted: Mon Mar 28, 2016 9:56 pm
by Bayou Bert
Well no inserts for me. I do have map as North up.
It's just the way I am used to looking at a map.
Darn and damn!

Thanks for the help, appreciate it.


Bert

Re: Map Page Insets

PostPosted: Wed Mar 30, 2016 3:06 pm
by gdtrfb58
I struggled with that for a while as I also prefer north up. Ultimately, I decided that the inserts are just too important (if you have a single screen), particularly if you are flying IFR.