Airspace information on map screen
Posted: Mon Dec 10, 2012 3:50 pm
I took a flight to Little Rock, AR from Shelbyville, TN the other day. When approaching a MOA the map page would not allow me to select the MOA to see the airspace information (push right hand knob and rotate to select). I could select Navaids, airports, and just about everything else except for the MOA's airspace. I was not going to penetrate it (it wasn't yellow) but I did want to see what the floor and ceiling were. Also, the floor and ceiling was not shown on the screen until AFTER I was through the MOA.
I also had the same problem with the Memphis airspace.
I have ver 8g. I have the most recent map database. The map was set to 35 NM range. In the set up I have show airspace set to 100 nm.
Any suggestions?
Mark
I also had the same problem with the Memphis airspace.
I have ver 8g. I have the most recent map database. The map was set to 35 NM range. In the set up I have show airspace set to 100 nm.
Any suggestions?
Mark