NavWorx ADS-B Setup with Hx

[bdtopp]

I have a NavWorx ADS-B and a dual display Hx system. The NavWorx RS232 Display Serial Data Input (Pin 24), and, the RS232 Display Serial Data Output (Pin 5) are connected to display unit #1 Serial 7 In and Serial 7 Out. When I am in the General Setup for Display Unit #1, what baud rate and value should I use when configuring Serial 7 in & out?

Thanks..

[Jerry Schneider]

I believe the answer is 115200 baud rate

[GRT_Jeff]

For the NavWorx ADS600-B

Serial Port 7 Rate: 115200
Serial Port 7 Input: ADS-B
Serial Port 7 Output: ADS600-B

The baud rate is also configured in the NavWorx unit and must match.

The "ADS600-B" output was added in HX software version 5c.

[bdtopp]

thanks

[330drvr]

Jeff: My Navworx is fed altitude from an HX serial port and the 327 transponder controls the squawk etc. What does selecting ADS600B on the EFIS to Navworx serial out do? I have always had the wire in place, but always in the off selection.

Thanks

[GRT_Jeff]

If your NavWorx unit is linked to another transponder, the only benefit of the output is the ability to change the call sign without connecting a computer to the maintenance port.

[330drvr]

Thanks Jeff