Roll servo override is not smooth
Posted: Fri Jun 21, 2019 5:21 pm
I'm still in gnd testing, so I get the pitch servo wont engage (but both servos respond to fwd and rev testing commands).
In testing the roll servo, when I try to override it, it notches or jumps like its skipping a gear tooth, ie its not a smooth override like when the servo is disengaged. Ive got the torque set at 5 and its the same "notchiness" and override pressure needed as when set at 10.
Is this the normal feeling of the override function? I'll note that I dont read anything in the AP manual that discusses what to expect, so hence the qu.
Thanks for any help.
In testing the roll servo, when I try to override it, it notches or jumps like its skipping a gear tooth, ie its not a smooth override like when the servo is disengaged. Ive got the torque set at 5 and its the same "notchiness" and override pressure needed as when set at 10.
Is this the normal feeling of the override function? I'll note that I dont read anything in the AP manual that discusses what to expect, so hence the qu.
Thanks for any help.