Cannot figure out how to change altimeter setting

Discussions and updates about the new Mini EFIS line.
Post Reply
MiniGA
Posts: 5
Joined: Tue Jan 17, 2023 5:17 am

Cannot figure out how to change altimeter setting

Post by MiniGA »

Manuel says from PFD page turn the knob, that changes my heading bug. Its a GA and reads GPS altutude or MSL I believe is what GPS altitude is, I would like to clear the big altimeter setting off the Mini GA screen altogether since we indicate MSL all the time, but I dont think you can clear it so I would like it to say 29.92 instead of 29.50 it is stuck on.

Thanks
MiniGA
Posts: 5
Joined: Tue Jan 17, 2023 5:17 am

Re: Cannot figure out how to change altimeter setting

Post by MiniGA »

When you update the Display software it will reset
GRT_Jeff
Posts: 802
Joined: Tue Dec 11, 2012 12:11 am

Re: Cannot figure out how to change altimeter setting

Post by GRT_Jeff »

It sounds like this Mini had a remote Air Data module connected. If that's not the case anymore you can go to SET MENU, General Setup, and look for a Serial Port Input configured for "GRT Air Data Module" and change that input to Off. Or you can reset all the settings as in the other post. If it has a remote air data module then you would rotate or push and rotate the knob on the PFD page to change the baroset.
Post Reply