GRT Avionics

Thanks Jeff. The update fixed the problem.

HXr/Mini. When running AP off the Mini, I get constant errors on the HXr "Roll trim required". Disconnecting the AP and the planes flies level with no trim required. How do I make it stop? I do not get the errors on running the AP from the HXr. All software is up to date and I started gett...

shhhhh. Mums the word.

I don't believe the info that Kahuna posted about setting the EIS scale to read tenths of a gallon is in any capacitive probe documentation but I think it should be. Kahuna, that works on the EIS 2000? Does it depend on the software version that's installed? I am not sure about that. I have the 6cy...

hmmm. Sounds like a guess. That fitting can go one way or another way 180 out.

For what ever reason my wires pulled out of the amp meter. Pic attached. I have a green blue and black wire. Ill solder back in place.
If the pins in the picture are 1,2 & 3 top to bottom, which wire goes where?

Good to know Jeff. THanks. That helps a lot.

Older unit you did have to cut I think it was a cap lead off on the board in order to wire to an EI. Newer units did not have this.
Im sure GRT will chime in with the details.

dmaib wrote:I see this occasionally, but I would estimate about 75% of the time it boots up in about 40 seconds.

Dave is your engine running during this boot period?

All our team is seeing this same behavior. On boot, get to PDF and there is a count down from ~40 sec on ahars. Then it resets to ~2:30 seconds and we essentially have a 3 min sit and wait period for the ahars to stabilize. This may not seem like a long time, but it is. How do we get this number to ...