GRT Avionics

Thanks Jeff,

Per our conversation, I updated both HXr's to latest Beta Version and just as you mentioned, it asked me if I wanted to update the AHRS and Safely Devices!!! Simply by answering yes and loading them. BINGO!

So easy, worked like a charm and everything working well...

Thanks again ...

Good Day Jeff,

Per our discussion the other night regarding whether or not to purchase the new add on hardware (uAvionix echoALT)... I am just off the phone with one of the uAvionix Tech reps and found some interesting things...

1. I explained my setup which was a DIRECT setup thru and with my HXr ...

Thanks Jeff,

Issue found (Pin #8 on AHRS was broken off in the connector) and not noticeable... amazing how accurate this GRT system is... IT knew exactly what was going on, it was the operator (me) that did not! LOL.

Re-pinned and working beautifully... thanks again for the quick support!

Merry ...

Good Day Jeff and All,

I was just completing backshell installation on my installation that was working well and after connecting all, received this error that I have never seen before.

Can you advise any trouble shooting steps on this one... wires "look" intact...

Photos of both my HXR-1 and ...

Good Afternoon Jeff,

I was hooking up my TCW Battery Voltage indicating wires to the Analog inputs as you described below (years ago!) and they worked PERFECTLY!

I have a question regarding where you state that you can send this input to another display (I assume this means it can then show on ...

Good Morning Jeff,

As a follow-up to the RS232 feed which you have written the Protocol for the Garmin interface, can you tell me how often for example the airspeed data is sent? Is it every time it sees a change in value or every x-seconds or?

Thanks,

Gary E
VELOCITY XLRG
ARB, MI

Thanks Jeff,

I will disconnect that hard programmed audio alert per your instructions.

Question: Since I have the AeroSafety Systems Annunciator System (pulls info from the HXr via the G3X format you programmed), which items should I have on and which off in that page shown in my screenshot?

Happy New Year Jeff, Jon and All,

When I turn on my master (EIS comes to life), I am getting a VERY annoying and loud audible beeping (warning) that oil pressure is too low. How do I silence this or, since I have a separate annunciator system (Aerosafety Systems AH502) with visual and audible ...

Hi, has anyone figured this one out, I have the same on new install Remote EIS and HXr's...

Hey Gary,



1. Either source would be equally accurate and suitable as a manifold pressure sensor source. It'll most likely be easier for you to use the Remote EIS's internal MAP sensor to get the data to your EFIS units, though.

2. Yes, you can connect the EIS MAP sensor by teeing off those lines ...